FREE TOOL
Spectrum image to CSV
Convert an infrared spectrum plot from an article, report or screenshot into numerical data. It is free, requires no registration and does not retain your image.
Review the result
The magenta line is the extracted curve; it should overlap the original curve. The blue numbers mark the ticks used to calibrate the X-axis and should match the plot.
The CSV has two columns: wavenumber (cm⁻¹) and intensity. The Excel CSV uses semicolons and a decimal comma to open directly in Portuguese-language Excel.
Tips for better results
- X-axis tick marks and values: the plot must have an X-axis line with tick marks and values. Without the values, reading fails. A complete frame (a four-sided box) helps, but is not required.
- Check the range: by default the calibration assumes values from 3500 to 500 cm⁻¹, in increments of 500. If your plot covers another range (for example, 3900, 3800, 3700… or only 1800 to 900), enter the first value and interval under “Calibrate the X-axis”. If the calibration does not match the plot, every band shifts, and this can go unnoticed.
- Full size, not enlarged: send the capture at its original size. Enlarging a small image does not bring back detail it does not have. The more pixels cover the plot, the more faithful the band positions; in small images, nearby bands are no longer separated.
- PNG, not JPEG: PNG preserves the line; heavily compressed JPEG blurs the curve and loses bands.
- Thin, clean line: one curve per plot, preferably colored (green, blue or red), with a thin stroke. A very thick stroke merges bands and can create bands that do not exist. Remove marked peaks, labels and shading drawn over the curve.
- Only the plot, whole: crop to the plot without captions, without cutting off the X-axis or the edges of the curve.
- Check the verification image: the extracted curve appears in magenta over your plot, with the blue numbers used to calibrate the axis. If the curve does not match or the numbers do not agree with the axis, do not use the result: adjust the calibration or send another image.
- An image is an approximation: band positions carry an uncertainty of a few cm⁻¹, and weak or very close bands may not appear. For values cited in reports or papers, use the numerical data exported from the instrument (CSV, JCAMP-DX or instrument file).
Each point comes from one image-pixel column, so the wavenumber resolution depends on the size of the chart. Image extraction is an approximation: for values cited in papers, prefer the numeric data exported from the instrument.